Construction Goods Shipping Services

Flatbed trailer is probably best.  

 

no exactly as pic, this one is a triaxle, gooseneck, pull with truck or on a trailer  

 

the building is located at the Hanna airport in alberta and needs to be relocated to kimberly bc  

 

 

Seller can arrange tilt and load tow truck to get machine from dock to ground level Sellers comment regarding shipping/packaging. Re packing it up, we could handle packaging the various parts that would be removed, mainly the outrigger and crosscut fence and the accessories. Things like the shaper fence, rip fence and jointer guard would likely best be left securely attached to the main body, unless you preferred otherwise. The main machine would not be packed per se but rather sit flat on the floor as there are no rollers on it. That what I did plus, because the rental truck had a heavy wooden floor, we screwed lengths of 2x4 around the edges of the machine so it would not slide then used heavy tie-downs to hold it from jumping out in case of bumps. It worked very well. I can provide you with some of the very heavy tie downs and even tie down eyes that can also be screwed or lag bolted to the floor at no cost to you. The saw should easily fit with a 5'x6' footprint leaving the slider mounted.  

 

 

 

Shipper shall submit to a verification of identity / information by Correctional Service Canada at his arrival, prior to admittance to the facility / site. Correctional Service Canada reserves the right to deny access to any facility / site or part thereof at any time.5.All services will be disconnected by the custodian. However, the shipper is responsible of dismantling.  

 

Business to business with Forklifts on either end for simplicity.  

Timing is flexible, does not have to be picked up and dropped off same day, but we do need sufficient notice to arrange for equipment and operator to be available for both locations.  

 

 

 

 

Delivery to contractors shop.  

need someone to pick up this machine with it's own lift put it on the truck and move it about 15km to another woodshop and unload with the lift.  

These materials are not currently packaged or 'wrapped' on a pallet - I would need details as to how you would want them packaged. The actual delivery is from Sault Ste. Marie, Ontario to Duncan, British Columbia - however, if transport through the United States is easier/cheaper, the address of pick up could be changed to some place in Michigan and drop off changed to an address in northern Washington near the B.C. border.  

 

 

I am very flexible on drop time and day. Pick up has to be made during week. I need to get this lumber latest end of month.. Want to find someone to work with on future shipments as well that go all over north america.